<< Hyper-V on FreeBSD10.0 | main | moto360かった >>

2014/04/18 金

APU 1C購入

あー具合わるい。とにかくダルイ。。
体調はいつも悪いのでそれは置いておいて、
以前のエントリーではALIXの購入を晒したわけだが、今回は同じPcenginesのAPU 1Cを購入したので軽く感想を。
使い道は、相変わらずのFireWall用。
よって、ソフトはm0n0wallを入れた。

ALIXとの違いは、
GeodeからBobcatになった。DualCoreCPUだ。
LANが100BASEからGigaBaseに変わった。チップはVIAからRealTekに変わった。
メモリが2GBになった。(FireWall目的だと、こんなにいらんけどね)

それでいて、ALIXとあまり値段は変わらない。3千円くらいの差かな。

スループットだが、単純なルーティングで 250Mbpsくらい出る。
ALIXだと100Baseなんで、その時点でアウトだったわけだが、、、
しかしながら、ローカルでのルーティングで250Mbps出たからなんなの?といった所。遅いもんは遅い。

一方、WANへの接続もGigaBaseとなったので、こちらもプロバイダ次第では威力を発揮するかも。とはいえ、スループットは、限界250Mbpsと考えておいたほうが良い。
CPUの負荷みても、50%いってしまってる(片方のコア、全開でつかってるのかな)

といったところで、現ALIXユーザは様子見して良いのではないかなと考える。
WANに対して、2.5倍得られるけど、ローカルでのルーティングで2.5倍程度だから。
まぁ、進化としては順当で、新規購入はALIXを選択せずAPU1Cのほうが良いだろう。

dmesgが気になる人は続きをどうぞ。
$ dmesg
Copyright (c) 1992-2013 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 8.4-RELEASE-p7 #0: Wed Jan 15 13:44:38 CET 2014
root@builder84.m0n0.ch:/usr/m0n0wall/build83/tmp/sys/i386/compile/M0N0WALL_GENERIC i386
gcc version 4.2.1 20070831 patched [FreeBSD]
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: AMD G-T40E Processor (1000.01-MHz 686-class CPU)
Origin = "AuthenticAMD" Id = 0x500f20 Family = 14 Model = 2 Stepping = 0
Features=0x178bfbff
Features2=0x802209
AMD Features=0x2e500800
AMD Features2=0x35ff
TSC: P-state invariant
real memory = 2115289088 (2017 MB)
avail memory = 2038722560 (1944 MB)
ACPI APIC Table:
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
FreeBSD/SMP: 1 package(s) x 2 core(s)
cpu0 (BSP): APIC ID: 0
cpu1 (AP): APIC ID: 1
ioapic0 irqs 0-23 on motherboard
wlan: mac acl policy registered
kbd0 at kbdmux0
cryptosoft0: on motherboard
acpi0: on motherboard
acpi0: [ITHREAD]
acpi0: Power Button (fixed)
Timecounter "ACPI-safe" frequency 3579545 Hz quality 850
acpi_timer0: <32-bit timer at 3.579545MHz> port 0x808-0x80b on acpi0
cpu0: on acpi0
cpu1: on acpi0
acpi_hpet0: iomem 0xfed00000-0xfed003ff on acpi0
Timecounter "HPET" frequency 14318180 Hz quality 900
pcib0: port 0xcf8-0xcff iomem 0xa0000-0xbffff on acpi0
pci0: on pcib0
pcib1: irq 16 at device 4.0 on pci0
pci1: on pcib1
re0: port 0x1000-0x10ff mem 0xf7a00000-0xf7a00fff,0xf7900000-0xf7903fff irq 16 at device 0.0 on pci1
re0: Using 1 MSI-X message
re0: ASPM disabled
re0: Chip rev. 0x2c000000
re0: MAC rev. 0x00000000
miibus0: on re0
rgephy0: PHY 1 on miibus0
rgephy0: none, 10baseT, 10baseT-FDX, 10baseT-FDX-flow, 100baseTX, 100baseTX-FDX, 100baseTX-FDX-flow, 1000baseT, 1000baseT-master, 1000baseT-FDX, 1000baseT-FDX-master, 1000baseT-FDX-flow, 1000baseT-FDX-flow-master, auto, auto-flow
re0: Ethernet address: 00:0d:b9
re0: [ITHREAD]
pcib2: irq 17 at device 5.0 on pci0
pci2: on pcib2
re1: port 0x2000-0x20ff mem 0xf7c00000-0xf7c00fff,0xf7b00000-0xf7b03fff irq 17 at device 0.0 on pci2
re1: Using 1 MSI-X message
re1: ASPM disabled
re1: Chip rev. 0x2c000000
re1: MAC rev. 0x00000000
miibus1: on re1
rgephy1: PHY 1 on miibus1
rgephy1: none, 10baseT, 10baseT-FDX, 10baseT-FDX-flow, 100baseTX, 100baseTX-FDX, 100baseTX-FDX-flow, 1000baseT, 1000baseT-master, 1000baseT-FDX, 1000baseT-FDX-master, 1000baseT-FDX-flow, 1000baseT-FDX-flow-master, auto, auto-flow
re1: Ethernet address: 00:0d:b9
re1: [ITHREAD]
pcib3: irq 18 at device 6.0 on pci0
pci3: on pcib3
re2: port 0x3000-0x30ff mem 0xf7e00000-0xf7e00fff,0xf7d00000-0xf7d03fff irq 18 at device 0.0 on pci3
re2: Using 1 MSI-X message
re2: ASPM disabled
re2: Chip rev. 0x2c000000
re2: MAC rev. 0x00000000
miibus2: on re2
rgephy2: PHY 1 on miibus2
rgephy2: none, 10baseT, 10baseT-FDX, 10baseT-FDX-flow, 100baseTX, 100baseTX-FDX, 100baseTX-FDX-flow, 1000baseT, 1000baseT-master, 1000baseT-FDX, 1000baseT-FDX-master, 1000baseT-FDX-flow, 1000baseT-FDX-flow-master, auto, auto-flow
re2: Ethernet address: 00:0d:b9
re2: [ITHREAD]
atapci0: port 0x4010-0x4017,0x4020-0x4023,0x4018-0x401f,0x4024-0x4027,0x4000-0x400f mem 0xf7f04000-0xf7f043ff irq 19 at device 17.0 on pci0
atapci0: [ITHREAD]
atapci0: AHCI v1.20 controller with 6 6Gbps ports, PM supported
ata2: at channel 0 on atapci0
ata2: [ITHREAD]
ata3: at channel 1 on atapci0
ata3: [ITHREAD]
ata4: at channel 2 on atapci0
ata4: [ITHREAD]
ata5: at channel 3 on atapci0
ata5: [ITHREAD]
ata6: at channel 4 on atapci0
ata6: [ITHREAD]
ata7: at channel 5 on atapci0
ata7: [ITHREAD]
ohci0: mem 0xf7f00000-0xf7f00fff irq 18 at device 18.0 on pci0
ohci0: [ITHREAD]
usbus0 on ohci0
ehci0: mem 0xf7f04400-0xf7f044ff irq 17 at device 18.2 on pci0
ehci0: [ITHREAD]
usbus1: EHCI version 1.0
usbus1 on ehci0
ohci1: mem 0xf7f01000-0xf7f01fff irq 18 at device 19.0 on pci0
ohci1: [ITHREAD]
usbus2 on ohci1
ehci1: mem 0xf7f04500-0xf7f045ff irq 17 at device 19.2 on pci0
ehci1: [ITHREAD]
usbus3: EHCI version 1.0
usbus3 on ehci1
pci0: at device 20.0 (no driver attached)
isab0: at device 20.3 on pci0
isa0: on isab0
pcib4: at device 20.4 on pci0
pci4: on pcib4
ohci2: mem 0xf7f02000-0xf7f02fff irq 18 at device 20.5 on pci0
ohci2: [ITHREAD]
usbus4 on ohci2
pcib5: at device 21.0 on pci0
pci5: on pcib5
ohci3: mem 0xf7f03000-0xf7f03fff at device 22.0 on pci0
ohci3: [ITHREAD]
usbus5 on ohci3
ehci2: mem 0xf7f04600-0xf7f046ff at device 22.2 on pci0
ehci2: [ITHREAD]
usbus6: EHCI version 1.0
usbus6 on ehci2
acpi_button0: on acpi0
atrtc0: port 0x70-0x71 irq 8 on acpi0
pmtimer0 on isa0
orm0: at iomem 0xee800-0xeffff pnpid ORM0000 on isa0
ata0: at port 0x1f0-0x1f7,0x3f6 irq 14 on isa0
ata0: [ITHREAD]
ata1: at port 0x170-0x177,0x376 irq 15 on isa0
ata1: [ITHREAD]
uart0: <16550 or compatible> at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
uart0: [FILTER]
uart0: console (115200,n,8,1)
uart1: <16550 or compatible> at port 0x2f8-0x2ff irq 3 on isa0
uart1: [FILTER]
acpi_throttle0: on cpu0
acpi_throttle1: on cpu1
acpi_throttle1: failed to attach P_CNT
device_attach: acpi_throttle1 attach returned 6
Timecounters tick every 1.000 msec
IPsec: Initialized Security Association Processing.
IP Filter: v4.1.34 initialized. Default = block all, Logging = enabled
md0: Prusbus0: 12Mbps Full Speed USB v1.0
usbus1: 480Mbps High Speed USB v2.0
usbus2: 12Mbps Full Speed USB v1.0
usbus3: 480Mbps High Speed USB v2.0
ugen0.1: at usbus0
uhub0: on usbus0
ugen1.1: at usbus1
uhub1: on usbus1
ugen2.1: at usbus2
uhub2: on usbus2
ugen3.1: at usbus3
uhub3: on usbus3
usbus4: 12Mbps Full Speed USB v1.0
usbus5: 12Mbps Full Speed USB v1.0
usbus6: 480Mbps High Speed USB v2.0
eloaded image 222ugen4.1: at usbus4
uhub4: on usbus4
ugen5.1: at usbus5
uhub5: on usbus5
ugen6.1: at usbus6
uhub6: on usbus6
41280 bytes at 0xc0e17fd4
SMP: AP CPU #1 Launched!
Root mount waiting for: usbus6 usbus5 usbus4 usbus3 usbus2 usbus1 usbus0
uhub4: 2 ports with 2 removable, self powered
uhub0: 5 ports with 5 removable, self powered
uhub2: 5 ports with 5 removable, self powered
uhub5: 4 ports with 4 removable, self powered
Root mount waiting for: usbus6 usbus3 usbus1
uhub6: 4 ports with 4 removable, self powered
uhub1: 5 ports with 5 removable, self powered
uhub3: 5 ports with 5 removable, self powered
ugen6.2: at usbus6
umass0: on usbus6